Home › Guides › Safety sensors and auto-reverse

Safety Sensors and Auto-Reverse, Explained

Automatic openers sold in the U.S. since the early 1990s must include entrapment protection. Here is how to check yours.

Two safety systems

  • Photo-eye sensors near the floor on each side reverse the door if the beam is broken.
  • Contact reversal reverses the door if it hits an obstruction.

A simple monthly check

  1. With the door open, wave an object (not a body part) through the sensor beam as it closes; it should reverse.
  2. Many manufacturers suggest placing a piece of wood flat on the floor in the door’s path; the door should reverse on contact. Follow your opener manual.

If either test fails, stop using the opener until it is serviced.

Door won’t close?

The most common cause is sensors knocked out of alignment, dirty lenses, or sun shining directly into a sensor. Clean and realign them, and check that both indicator lights are on.

Garage door giving you trouble?

Tell us what the door is doing and where you are. It takes about a minute, and there is no obligation.

Request service

More reading

Torsion and extension springs explained

How springs balance a door and why they break.

West Texas garage door care

Heat, wind, dust and hail.

Repair or replace a garage door?

When a repair makes sense and when a new door does.

Request service